PhDHES 3D Atomic Flow Booster Stem for Arizer Air and Solo
PlanetHaze Designs High Efficiency Stems (PhDHES) take your Arizer Air or Solo to the Next Level with these custom Glass Stems utilizing our High Efficiency Technology to improve airflow by 30% while still maintaining thick, dense vapor clouds. Extract more from your flowers in less time, improving on efficiency by more evenly and thoroughly vaporizing your flowers.
- Arizer Solo
- Arizer Solo II
- Arizer Air
- Arizer Air II
Best Seller Worldwide
PhDHES 3D Atomic Flow Booster Stem
- Dense Vapor: The pinches along the entire stem length, slows down the air flow increasing vapor density.
- Denser Glass: The stems glass is more resistant to shocks due to the internal thickness obtained by the crossings of the internal peaks.
- Decreased Vapor Temperature: Lower vapor temperature is acheived by doubling the vapor path distance to allow for cooling of the vapor while retaining the original stem length.
- (1) x PhDHES 3D Atomic Flow Booster Stem for Arizer Air and Solo
- (1) x Custom Stainless Steel Stem Screen
- Grind your flowers to a medium – fine consistency, recommended to use our Volcano Grinder
- Fill the bowl on your PhDHES all the way and very very lightly pack a bit
- Holding your Air or Solo upside down, insert the PhDHES Stem all the way in and then turn the Air or Solo the right way up
- Turn your Air or Solo on and heat to your desired temperature (minimum 3 for Air, 5 for Solo and 200C for Air2 / Solo2 recommended to start) with PhDHES inserted during warm up
- Once Air or Solo reaches your selected temperature wait an extra 45 seconds to heat soak your biomass and PhDHES
- Take a nice long slow inhalation
- Wait 30 seconds between hits to allow your Air or Solo to stabilize
- Due to much less air flow resistance of the PhDHES, resist the urge to inhale too fast, overwhelming the Air or Solo’s heater
- Always keep the PhDHES stem in the Air or Solo to retain heat
- You can raise the temperature to Maximum to get the full spectrum from your flowers
- Bowl is spent when there is no more vapor production
- Always empty spent bowl while it is still at its hottest, a cool bowl is much harder to empty cleanly
Look For The Authorized Logo!
Always look for the Authorized Logo to ensure you are buying a Genuine PhDHES 3D Atomic Flow Booster Stem. Don’t take chances with your health, only buy from an Authorized Distributor to ensure you are getting Genuine Authentic PlanetHaze Designs PhDHES products. The advantage of buying from an authorized distributor is you will always get a Genuine PhDHES 3D Atomic Flow Booster Stem. You will also be fully covered by any manufactures warranty and you will receive the best service possible.
Disclaimer: PlanetHaze is not responsible for any damage or personal injury caused by or from using our products. Glass is breakable and sharp, please use accordingly.